Figure 12. Installing a sled
2. Push the blue retention latch to slide the sled into the enclosure, and stop the sled at a distance of 20-30 mm before
complete insertion of the sled as shown in the image below.
CAUTION:
To avoid any damages to the pins on the sled, do not force the sled into the enclosure. Follow the
two-position insertion and gently slide the sled into the enclosure.
Figure 13. Stop the sled at a distance of 20-30 mm before complete insertion
3. Slide the blue retention latch gently, until the sled locks into the place.
20
Installing and removing system components
To Next Page
Loading...
