2. Create the VD:
/opt/MegaRAID/perccli/perccli64 /c0 add vd type=raid0 drives=<EID>:<Slt> direct wt nora
Example:
opt/MegaRAID/perccli/perccli64 /c0 add vd type=raid0 drives=32:0 direct wt nora
where
EID
and
Slt
are the Enclosure ID and Slot ID values, which in this example are 32:0.
Results
The VD was created successfully.
After you finish
Continue with the procedure that referred you to this topic.
Ensure virtual drive creation with PERCCLI
Use the PERCCLI utility to ensure that a virtual drive (VD) was created properly on each drive.
Procedure
1. Log in to the server.
2. Display the physical device (PD) information:
/opt/MegaRAID/perccli/perccli64 /c0/eall/sall show
Output similar to the following is displayed:
3. Verify that all the devices have a virtual drive created on them.
In the Drive Information output, the device state displayed as "Onln" in the State column shows that the device
has a virtual drive created on it.
4. Display device group (DG) and virtual drive (VD) information:
/opt/MegaRAID/perccli/perccli64 /c0/vall show
Preparing Disks
60 VxFlex Ready Node Operating System Installation Guide for Linux
To Next Page
Loading...
