Dell EMC VxFlex Ready Node - Retrieving Device Paths in a Linux Server with Nvme Devices Configured

The output displays the device groups (DG) and their associated VD.
3. Match a VD to a device path:
a. Run the following command:
ls –l /dev/disk/by-path/
Output similar to the following appears:
b. In the command output, search for the line:
pci-0000:02:00.0-scsi-0:2:X:0
where X is the number assigned to the VD.
c. In the line you just located, search for the sdX at the end of the line.
The device path for the VD is /dev/sdX.
Use this path when adding devices to a VxFlex OS SDS.
Retrieving device paths in a Linux server with NVMe devices configured
Retrieve the OS device paths in a Linux-based VxFlex Ready Node server with NVMe devices configured.
Before you begin
Ensure that you have root access to the server
Procedure
1. Log in to the server.
Preparing Disks
VxFlex Ready Node Operating System Installation Guide for Linux 63