Dell EMC VxFlex Series - Page 57

l
Removing all the existing VDs from the node
l
Setting up the controller card boot parameter
Procedure
1. Log in to the node.
2. Display the disk information on the node:
/opt/lsi/perccli/perccli /c0/eall/sall show
Output similar to the following is displayed:
The output shows the following:
l
Enclosure ID (EID): Used in a later step when creating VDs
l
Slot ID (SLT) of each drive: Used in a later step when creating VDs
l
Drive type: Displays SSD or HDD as the device type. (SSD drives are smaller
—744 GB in this case.)
l
Drive state: Should be UGood (unused and good)
3. Verify that the VDs exist on the node:
/opt/lsi/perccli/perccli /c0/vall show
Output similar to the following is displayed:
If the output confirms that VDs exist on the node, perform the next step to
remove them. Otherwise, skip the step.
4. Remove all existing VDs from the node:
/opt/lsi/perccli/perccli /c0/vall del
The VDs are removed.
Preparing Disks
Verify the storage and disk controller status 57