Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Flat-head screwdriver
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Secured to Screw type Quantity Screw image
Base cover Palm-rest and keyboard
assembly
M2x6 4
NOTE: Screw color
may vary depending
on the configuration
ordered.
4-cell Battery Palm-rest and keyboard
assembly
M2x4 4
Touchpad bracket Palm-rest and keyboard
assembly
M2x2 7
Rear cover Palm-rest and keyboard
assembly
M2x2 2
Rear cover Palm-rest and keyboard
assembly
M2.5x5 2
Display-hinge brackets Palm-rest and keyboard
assembly
M2.5x4 4
SSD1 Solid-state drive bracket M2x4 2
2
Removing and installing components 9
To Next Page
Loading...
