Table 29. System setup options—Integrated Devices menu (continued)
Integrated Devices
Date Sets the computer date in MM/DD/YYYY format. Changes to the date take
effect immediately.
Time Sets the computer time in HH/MM/SS 24-hour format. You can switch
between 12-hour and 24-hour clock. Changes to the time take effect
immediately.
Memory Mapped I/O above 4 Gig Enables or disables the Memory Mapped I/O above 4 GB.
Default: ON
Camera
Enable Camera Enables or disables the camera.
By default, Enable Camera is selected.
Audio
Enable Audio Enables or disables all integrated audio controller.
Default: ON
Enable Microphone Enables or disables microphone.
By default, Enable Microphone is selected.
Enable Internal Speaker Enables or disables internal speaker.
By default, Enable Internal Speaker is selected.
USB/Thunderbolt Configuration
Enable External USB Ports Enables or disables external USB ports.
Default: ON
Enable USB Boot Support Enables or disables USB Boot Support.
Default: ON
Enable Thunderbolt Boot Support Enable or disable the Thunderbolt adapter peripheral device and USB devices
connected to the Thunderbolt adapter to be used during BIOS Pre-boot.
Default: OFF
Enable Thunderbolt (and PCI behind TBT)
pre-boot modules
Enable or disable the PCIe devices that are connected through a Thunderbolt
adapter to execute the PCIe devices UEFI Option ROM (if present) during
pre-boot.
Table 30. System setup options—Storage menu
Storage
SATA/NVMe Operation
SATA/NVMe Operation Configures operating mode of the integrated storage device controller.
Default: RAID On. Storage device is configured to support RAID functions.
When enabled, all NVMe and SATA devices will be mapped under VMD
controller. Windows RST (Intel Rapid Restore Technology) driver, or Linux
kernel VMD driver must be loaded in order to boot the OS.
Storage Interface
Port Enablement Enables or disables the onboard drives.
Default: ON
SMART Reporting
BIOS setup 85
To Next Page
Loading...
