Steps
1. Open the latch and disconnect the display cable from the system board.
2. Remove the screw (M2x4) that secures the display cable to the palm-rest and keyboard assembly.
3. Flip the computer over.
4. Remove the eight screws (M2.5x5) that secure the display-assembly hinges to the palm-rest and keyboard assembly.
5. Lift the hinges from the palm-rest and keyboard assembly.
6. Slide the display assembly from the palm-rest and keyboard assembly.
7. After performing all the above steps, you are left with the display assembly.
Removing and installing components
25
To Next Page
Loading...
