Steps
1. Fold the keyboard cable.
2. Align the screw holes on the keyboard and keyboard bracket with the screw holes on the palm-rest and keyboard assembly.
3. Replace the 41 screws (M1.2x2.5) that secure the keyboard bracket to the palm-rest and keyboard assembly.
Next steps
1. Install the touchpad.
2. Install the G key.
3. Install the system board.
4. Install the I/O board.
5. Install the light bar.
6. Install the power button with optional fingerprint reader.
7. Install the power-adapter port.
8. Install the graphics-card fan.
9. Install the processor fan.
10. Install the memory modules.
11. Install the M.2 2280 solid-state drive or M.2 2230 solid-state drive.
12. Install the wireless card.
13. Install the display assembly.
14. Install the rear-cover bracket.
15. Install the rear cover.
16. Install the coin-cell battery.
17. Install the battery.
18. Install the base cover.
19. Follow the procedure in After working inside your computer.
64
Removing and installing components
To Next Page
Loading...
