system1 has been stopped successfully
• To switch on the server:
start /system1
The following message is displayed:
system1 has been started successfully
• To reboot the server:
reset /system1
The following message is displayed:
system1 has been reset successfully
SEL management
The following examples show how to use the SMCLP to perform SEL-related operations on the managed system. Type the
following commands at the SMCLP command prompt:
• To view the SEL:
show/system1/logs1/log1
The following output is displayed:
/system1/logs1/log1
Targets:
Record1
Record2
Record3
Record4
Record5
Properties:
InstanceID = IPMI:BMC1 SEL Log
MaxNumberOfRecords = 512
CurrentNumberOfRecords = 5
Name = IPMI SEL
EnabledState = 2
OperationalState = 2
HealthState = 2
Caption = IPMI SEL
Description = IPMI SEL
257
To Next Page
Loading...
