Replacing the speakers
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1 Using the tabs on the speakers, place the speakers in the slots on the
palm rest and keyboard assembly and snap the speakers into place.
2 Route the speaker cable through the routing guides on the palm rest and
keyboard assembly.
3 Adhere the tape that secures the speaker cable to the palm rest and
keyboard assembly.
4 Connect the speaker cable to the system board.
5 Route the power and volume-buttons board cable through the routing
guides on the speaker and the palm rest and keyboard assembly.
6 Connect the power and volume-buttons board cable and the coin-cell
battery cable to the I/O board.
Post-requisites
1 Replace the battery.
2 Replace the base cover.
56
To Next Page
Loading...
