Dell Inspiron 16 5645 - Installing the Memory Module

3. Slide the memory module at an angle and remove it from the memory-module slot (DIMM A DDR5 ONLY or DIMM B DDR5
ONLY) on the system board.
Installing the memory module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the memory module and provide a visual representation of the installation
procedure.
NOTE: Inspiron 16 5645 supports a dual-channel RAM memory configuration.
Figure 11. Installing the memory module
Steps
1. Lift the Mylar to access the memory-module slot.
2. Align the notch on the memory module with the tab on the memory-module slot (DIMM A DDR5 ONLY or DIMM B DDR5
ONLY) on the system board.
42
Removing and installing Customer Replaceable Units (CRUs)