Figure 31. Installing the I/O-board cable
Steps
1. Place the I/O-board cable on the palm-rest and keyboard assembly.
2. Connect the I/O-board cable to its connector on the I/O board and close the latch.
3. Connect the I/O-board cable to its connector (IO) on the system board and close the latch.
Next steps
1. Install the fan.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
I/O board
Removing the I/O board
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following images indicate the location of the I/O board and provide a visual representation of the removal procedure.
70
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
