Figure 39. Removing the power-adapter port
Steps
1. Remove the two screws (M2.5x5) that secure the hinge to the system board and the palm-rest and keyboard assembly.
2. Pry open the hinge away from the palm-rest and keyboard assembly to access the power-adapter port.
3. Disconnect the power-adapter port cable from its connector (DCIN) on the system board.
4. Remove the power-adapter port cable through the guide on the palm-rest and keyboard assembly.
5. Remove the power-adapter port from the slot on the palm-rest and keyboard assembly.
NOTE:
The power-adapter port is secured in place by the hinge. There is no screw, tape, or adhesive securing the
power-adapter port to the palm-rest. Technicians should ensure that the power-adapter port has not fallen out when
the right hinge is removed.
Installing the power-adapter port
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power-adapter port and provide a visual representation of the installation
procedure.
78
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
