6. Carefully lift and remove the system board from the palm-rest and keyboard assembly.
Installing the system board
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
When installing the system board to replace/access other parts, the system board can be installed with the heat
sink to it in order to simplify the procedure and preserve the thermal bond between the system board and heat sink.
The following image indicates the connectors on your system board.
Removing and installing Field Replaceable Units (FRUs)
83
To Next Page
Loading...
