Figure 32. Removing the I/O board
Steps
1. Remove the three screws (M2.5x5) that secure the hinge to the palm-rest and keyboard assembly.
2. Pry open the hinge away from the palm-rest and keyboard assembly to access the I/O board.
3. Open the latch and disconnect the I/O-board cable from its connector on the I/O board.
4. Open the latch and disconnect the fingerprint reader cable from the I/O board.
NOTE: This step applies only to computers shipped with a fingerprint reader installed.
5. Remove the three screws (M2x3.5) that secure the I/O board to the palm-rest and keyboard assembly.
6. Carefully slide and remove the I/O board at angle, from the palm-rest and keyboard assembly.
Installing the I/O board
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the I/O board and provide a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
71
To Next Page
Loading...
