Figure 29. Installing the display assembly
Steps
1. Place the display assembly on a clean and flat surface.
2. Slide the palm-rest and keyboard assembly at an angle and place the palm-rest and keyboard assembly on the display
assembly.
NOTE:
The power-adapter port is secured in place by the left hinge. There is no screw, tape, or adhesives securing the
power-adapter port to the palm-rest. Technicians should ensure that the power-adapter port has not fallen out when
the left hinge is removed.
3. Gently press down on the hinges to align the screw holes on the hinges with the screw holes on the palm-rest and keyboard
assembly.
4. Connect the display cable to its connector (eDP) on the system board.
5. Replace the five screws (M2.5x5) that secure the display assembly to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
I/O-board cable
Removing the I/O-board cable
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the fan.
About this task
The following image indicates the location of the I/O-board cable and provides a visual representation of the removal procedure.
68
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
