Figure 19. Installing the fan
Steps
1. Place and align the fan, along with fan cable, in the slot on the palm-rest and keyboard assembly.
2. Align the screw holes on the fan to the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x5.5) that secure the fan to the palm-rest and keyboard assembly.
4. Connect the fan cable to its connector (FAN) on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing and installing Customer Replaceable Units (CRUs)
53
To Next Page
Loading...
