Figure 27. Installing the touchpad assembly
Steps
1. Align and place the touchpad, along with the touchpad cable, in the slot on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x2.3) that secure the touchpad assembly to the palm-rest and keyboard assembly.
3. Place the touchpad bracket in the slot on the palm-rest and keyboard assembly.
4. Align the screw holes on the touchpad bracket to the screw holes on the palm-rest and keyboard assembly.
5. Replace the five screws (M2x2.3) that secure the touchpad bracket to the palm-rest and keyboard assembly.
6. Connect the touchpad cable to its connector (TP) on the system board and close the latch.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
64
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
