Steps
1. Using the alignment posts, place the front speakers on the palm-rest and keyboard assembly.
NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
2. Route the front-speaker cable through the routing guides on the system board and palm-rest and keyboard assembly.
3. Adhere the tapes that secure the front-speaker cable to the palm-rest and keyboard assembly.
4. Conect the front-speaker cable to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing the front speakers, 6-cell battery (87 Wh)
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: This procedure only applies for computers shipped with a 6-cell battery (87 Wh) installed.
The following image(s) indicate the location of the front speakers, 6-cell battery (87 Wh) and provides a visual representation of
the removal procedure.
Removing and installing components
29
To Next Page
Loading...
