Removing the camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the stand assembly.
2 Remove the back cover.
Procedure
1 Disconnect the microphone and camera cable from the system board.
2 Note the microphone and camera cable routing and remove the cable
from its routing guides on the display-assembly base.
3 Follow the procedure from step 4 to step 6 in ”Removing the
microphone".
4 Using your fingertips, press the securing clip and lift the camera module.
5 Disconnect the camera module from the tab on the camera module-slot
on the display bezel.
6 Lift the camera module away from the display bezel.
47
To Next Page
Loading...
