Removing the rubber feet
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the stand assembly.
2 Remove the back cover.
3 Remove the optical drive.
4 Remove the hard drive.
5 Remove the memory module.
6 Remove the wireless card.
7 Remove the heat sink.
8 Remove the fan.
9 Remove the microphone.
10 Remove the camera.
11 Remove the system board.
12 Remove the VESA-mount bracket.
13 Remove the speaker cover.
14 Remove the speakers.
15 Remove the control-buttons board.
16 Remove the display assembly.
Procedure
1 Remove the screws that secure the rubber feet to the display bezel.
74
To Next Page
Loading...
