Removing the control-buttons
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the stand assembly.
2 Remove the back cover.
3 Remove the VESA-mount bracket.
Procedure
1 Lift the latch and disconnect the control-buttons board cable from the
system board.
2 Note the control-buttons board cable routing and peel it off from its
routing guides on the display-assembly base.
3 Using your fingertips, press the securing clips on the control-buttons
board slot.
4 Lift the control-buttons board off the display bezel.
64
To Next Page
Loading...
