Replacing the camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Connect the microphone and camera cable to the camera module.
2 Push the tabs on the camera module into the tab on the camera-module
slot.
3 Press the camera module down into the slot on the display bezel until it
snaps into place.
4 Follow the procedure from step 1 to step 2 in ”Replacing the
microphone".
5 Route the microphone and camera cable through the routing guides on
the display-assembly base.
6 Connect the microphone and camera cable to the system board.
Post-requisites
1 Replace the back cover.
2 Replace the stand assembly.
49
To Next Page
Loading...
