Replacing the rubber feet
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the rubber feet with the screw holes on the
display bezel.
2 Replace the screws that secure the rubber feet to the display bezel.
Post-requisites
1 Replace the display assembly.
2 Replace the control-buttons board.
3 Replace the speakers.
4 Replace the speaker cover.
5 Replace the VESA-mount bracket.
6 Replace the system board.
7 Replace the camera.
8 Replace the microphone.
9 Replace the fan.
10 Replace the heat sink.
11 Replace the wireless card.
12 Replace the memory module.
13 Replace the hard drive.
14 Replace the optical drive.
15 Replace the back cover.
16 Replace the stand assembly.
76
To Next Page
Loading...
