Replacing the camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Adhere the camera to the camera frame.
2 Connect the camera cable to the camera.
3 Connect the camera assembly to the tabs on the display bezel
4 Press the camera assembly into the slot on the display bezel till the
securing clip locks in place.
5 Route the antenna, microphone, and camera cables through the routing
guides on the middle cover and display bezel.
Post-requisites
1 Replace the back cover.
2 Replace the stand.
55
To Next Page
Loading...
