Dell Inspiron 24 5000 Series - Replacing the Rubber Feet; Procedure; Post-Requisites

Replacing the rubber feet
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the rubber foot with the screw holes on the
display bezel.
2 Replace the screw that secures the rubber foot to the display assembly.
Post-requisites
1 Replace the middle cover.
2 Replace the speaker cover.
3 Replace the VESA-mount bracket.
4 Replace the system board.
5 Replace the fan.
6 Replace the heat sink.
7 Replace the wireless card.
8 Replace the hard drive.
9 Replace the optical drive.
10 Replace the back cover.
11 Replace the stand.
83