Dell Inspiron 3595 - Replacing the Display Bezel

Procedure
NOTE: This procedure is applicable only for computers shipped with non-touchscreen displays.
1.
Using a plastic scribe, carefully pry up the display bezel from the top-left outer edge of the display back-cover and antenna assembly.
2. Remove the display bezel off the display back-cover and antenna assembly.
Replacing the display bezel
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
NOTE:
This procedure is applicable only for computers shipped with non-touchscreen displays.
Align the display bezel with the display back-cover and antenna assembly, and then gently snap the display bezel into place.
64
Removing and installing components