Post-requisites
1. Replace the display assembly.
2. Replace the wireless card.
3. Replace the base cover.
4. Replace the optical drive (applicable only to computers shipped with optical drive).
Camera
Removing the camera
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1. Remove the optical drive (applicable only to computers shipped with optical drive).
2. Remove the base cover.
3. Remove the wireless card.
4. Remove the display assembly.
5. Remove the display bezel.
Procedure
NOTE:
This procedure is applicable only for computers shipped with non-touchscreen displays.
1. Using a plastic scribe, gently pry the camera off the display back-cover and antenna assembly.
2. Disconnect the camera cable from the camera module.
3. Lift the camera module from the display back-cover and antenna assembly.
Removing and installing components
65
To Next Page
Loading...
