Removing the Power-Button
Module
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Prerequisites
1 Remove the computer cover.
2 Remove the front bezel.
3 Follow the procedure from step 1 to step 5 in “Removing the drive cage”.
Procedure
1 Disconnect the power-button module cable from the system-board
connector (LEDH1).
For more information on the location of the cable connector, see
“System-Board Components”.
2 Remove the power-button module cable from the routing guides on the
chassis.
3 Press the power-button module tabs to release the power-button
module from the front panel.
42
To Next Page
Loading...
