Prerequisites
1 Remove the computer cover.
2 Follow the procedure from step 1 to step 5 in “Removing the drive cage”.
Procedure
1 Locate the password jumper (PSWD1) on the system board.
For more information on the location of password jumper, see “System-
Board Components”.
2 Remove the password jumper plug.
1 jumper plug 2 CMOS jumper (CMCL R2)
3 password jumper (PSWD1)
3 Follow the procedure from step 3 to step 6 in “Replacing the drive cage”.
4 Replace the computer cover.
5 Turn on your computer and wait till the operating system is completely
loaded.
6 Move your mouse pointer to the upper-right or lower-right corner of the
screen to open the charms sidebar, and then click or tap Settings →
Power → Shut down.
7 Remove the computer cover.
8 Follow the procedure from step 1 to step 5 in “Removing the drive cage”.
9 Replace the password jumper plug on the password jumper.
Post-requisites
1 Follow the procedure from step 3 to step 6 in “Replacing the drive cage”.
2 Replace the computer cover.
52
To Next Page
Loading...
