Replacing the Power-Button
Module
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Align and push the power-button module tabs into the slots on the front
panel.
2 Align the power-button module cable on the routing guides on the
chassis.
3 Connect the power button module cable to the system board connector
(LEDH1).
For more information on the location of the cable connector, see
“System-Board Components”.
Post-requisites
1 Follow the procedure from step 3 to step 6 in “Replacing the drive cage”.
2 Replace the front bezel.
3 Replace the computer cover.
44
To Next Page
Loading...
