VGA-connector board
Removing the VGA-connector board
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
About this task
NOTE: For computers shipped with 10th Generation Intel Core i5-10400F and 10th Generation Intel Core i7-10700F
processors a VGA-connector cover is installed over the VGA connector and needs to be removed when the VGA-
connector board is removed.
The following image(s) indicate the location of the VGA-connector board and provides a visual representation of the removal procedure.
Steps
1. Lay the computer with its right side facing down.
2. Loosen the two captive screws that secure the VGA-connector cover to the VGA connector. (if applicable)
Removing and installing components 25
To Next Page
Loading...
