Steps
1. Slide in place the VGA-connector board into its slot on the chassis.
2. Replace the two screws (6-32) that secure the VGA-connector board to the chassis.
3. Connect the VGA-connector board cable to the system board.
4. Place the VGA-connector cover over the VGA connector. (if applicable)
5. Tighten the two captive screws that secure the VGA-connector cover to the VGA connector. (if applicable)
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Power-supply unit
Removing the power supply
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
About this task
The following image(s) indicate the location of the power supply and provides a visual representation of the removal procedure.
Removing and installing components 27
To Next Page
Loading...
