3. Remove the VGA-connector cover from the VGA connector. (if applicable)
4. Using the pull tab, disconnect the VGA-connector board cable from the system board.
5. Using the pull tab, disconnect the VGA-connector board cable from the system board.
6. Remove the two screws (6-32) that secure the VGA-connector board to the chassis.
7. Slide and lift the VGA-connector board from the chassis.
Installing the VGA-connector board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: For computers shipped with 10th Generation Intel Core i5-10400F and 10th Generation Intel Core i7-10700F
processors a VGA-connector cover is installed over the VGA connector and must be installed after the VGA-connector
board has been installed.
The following image(s) indicate the location of the VGA-connector board and provides a visual representation of the installation
procedure.
26 Removing and installing components
To Next Page
Loading...
