Removing the touchpad
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1. Remove the base cover.
2. Remove the battery.
Procedure
1. Peel off the tapes that secure the touchpad to the palm-rest and keyboard assembly.
2. Peel off the tape that secures the speaker cable to the touchpad.
3. Open the latch and disconnect the hard-drive cable from the system board.
4. Open the latch and disconnect the touchpad cable from the system board.
5. Remove the three screws (M2x2 Big Head) that secure the touchpad bracket to the palm-rest and keyboard assembly.
6. Lift the touchpad bracket off the palm-rest and keyboard assembly.
7. Remove the four screws (M2x2 Big Head) that secure the touchpad to the palm-rest and keyboard assembly.
8. Lift the touchpad off the palm-rest and keyboard assembly.
24
Removing the touchpad 41
To Next Page
Loading...
