Removing the display assembly
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1. Remove the base cover.
2. Remove the wireless card.
Procedure
1. Peel off the tape that secures the I/O-board cable to the I/O board.
2. Note the routing and remove the I/O-board cable from the routing guides.
3. Peel off the tape that secures the display cable to the display cable connector.
4. Open the latch and disconnect the display cable from the system board.
5. Remove the antenna cable from the routing guide.
6. Remove the four screws (M2.5x5) that secure the display hinges to the palm-rest and keyboard assembly.
30
Removing the display assembly 51
To Next Page
Loading...
