Replacing the power button with fingerprint
reader
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
NOTE: Applicable only for computers that are shipped with fingerprint reader.
Procedure
1. Align the screw holes on the power button with fingerprint reader with the screw holes on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x3) that secure the power button with fingerprint reader to the palm-rest and keyboard assembly.
3. Adhere the fingerprint-reader cable and the fingerprint-reader board to the palm-rest and keyboard assembly.
Post-requisites
1. Replace the I/O board.
2. Replace the display assembly.
3. Replace the fan.
4. Replace the base cover.
33
Replacing the power button with fingerprint reader 57
To Next Page
Loading...
