5. Disconnect the power-adapter port cable from the system board.
6. Remove the two screws (M2x3) that secure the USB Type-C port bracket to the system board.
7. Lift the USB Type-C port bracket off the system board.
8. Disconnect the speaker cable from the system board.
9. Open the latch and disconnect the keyboard cable from the system board.
10. Open the latch and disconnect the keyboard-backlight cable (optional) from the system board.
NOTE: Applicable only if your computer is shipped with a backlit keyboard.
11. Open the latch and disconnect the touchpad cable from the system board.
12. Open the latch and disconnect the hard-drive cable from the system board.
13. Disconnect the coin-cell battery cable from the system board.
14. Remove the four screws (M2x2) that secure the system board to the palm-rest and keyboard assembly.
15. Lift the system board off the palm-rest and keyboard assembly.
Removing the system board
61
To Next Page
Loading...
