Optical Drive 21
Replacing the Optical Drive
1
Follow the instructions in "Before You Begin" on page 9.
2
Align the tabs on the optical-drive bezel with the slots on the optical drive
and snap the optical-drive bezel into place.
3
Align the screw holes on the optical-drive bracket with the screw holes on
the optical drive and replace the two screws.
4
Slide the optical-drive assembly into the optical-drive compartment until
it is fully seated.
5
Replace the screw that secures the optical-drive assembly to the computer
base.
6
Replace the module cover (see "Replacing the Module Cover" on page 18).
7
Replace the battery (see "Replacing the Battery" on page 16).
CAUTION: Before turning on the computer, replace all screws and ensure that no
stray screws remain inside the computer. Failure to do so may result in damage to
the computer.
1 screws (2) 2 optical-drive bracket
3 optical drive 4 optical-drive bezel
To Next Page
Loading...
