56 Display
Replacing the Display Assembly
1
Follow the instructions in "Before You Begin" on page 9.
2
Place the display assembly in position and replace the four screws that
secure the display assembly to the computer base.
3
Route the display cable and Mini-Card antenna cables through the routing
guides.
4
Connect the display cable to the connector on the system board.
5
Connect the Mini-Card antenna cables to the Mini-Cards(s) (see
"Replacing the Mini-Card(s)" on page 47).
6
Tighten the display cable grounding screw.
1 display assembly 2 screws (4)
To Next Page
Loading...
