Hard-Drive Assembly 97
Replacing the Hard-Drive Assembly
1
Follow the instructions in "Before You Begin" on page 9.
2
Remove the new hard drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
3
Place the hard drive in the hard-drive bracket.
4
Replace the four screws that secure the hard-drive bracket to the hard
drive.
5
Place the hard-drive assembly on the system board.
6
Slide the hard-drive assembly to connect it to the connector on the system
board.
7
Replace the screw that secures the hard-drive assembly to the system
board.
1 screws (4) 2 hard-drive bracket
3 hard drive
To Next Page
Loading...
