48 Wireless Mini-Card(s)
5
Press the other end of the Mini-Card down into the slot on the system
board and replace the screw that secures the Mini-Card to the system
board.
6
Connect the appropriate antenna cables to the Mini-Card you are
installing.
The following table provides the antenna cable color scheme for the
Mini-Cards supported by your computer.
7
Replace the palm-rest assembly (see "Replacing the Palm-Rest Assembly"
on page 35).
8
Replace the keyboard (see "Replacing the Keyboard" on page 29).
9
Follow the instructions from step 4 to step 5 in "Replacing the Optical
Drive" on page 21.
10
Replace the module cover (see "Replacing the Module Cover" on page 18).
11
Replace the battery (see "Replacing the Battery" on page 16).
CAUTION: Before turning on the computer, replace all screws and ensure that no
stray screws remain inside the computer. Failure to do so may result in damage to
the computer.
12
Install the drivers and utilities for your computer, as required.
NOTE: If you are installing a communication card from a source other than Dell,
you must install the appropriate drivers and utilities.
Connectors on the Mini-Card Antenna Cable Color Scheme
WLAN (2 antenna cables)
Main WLAN (white triangle)
Auxiliary WLAN (black triangle)
white
black
WiMax (2 antenna cables)
Main WiMax (white triangle)
Auxiliary WiMax (black triangle)
white with gray stripe
black with gray stripe
To Next Page
Loading...
