76 Thermal-Cooling Assembly
Replacing the Thermal-Cooling Assembly
1
Follow the instructions in "Before You Begin" on page 9.
2
Align the screw holes on the thermal-cooling assembly with the screw
holes on the system board.
3
Tighten the five screws that secure the thermal-cooling assembly to the
system board.
4
Connect the fan cable to the connector on the system board.
5
Adhere the tape that secures the fan cable to the system board
6
Follow the instructions from step 4 to step 13 in "Replacing the System
Board" on page 67.
7
Replace the battery (see "Replacing the Battery" on page 16).
1 captive screws (5) 2 system board
3 thermal-cooling assembly 4 fan cable
To Next Page
Loading...
