116 Adding and Replacing Parts
www.dell.com | support.dell.com
PC Card With Bluetooth
®
Wireless Technology
CAUTION: Before you begin this procedure, read the safety instructions at the front of this document
(see page 11).
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching a connector on the back panel of the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin
working inside the computer.
If you ordered a PC Card with Bluetooth wireless technology with your computer, it is already
installed.
1
Remove the battery (see page 52).
2
Open the card door.
3
Using a plastic scribe or screwdriver, gently pry the module from the plastic guide bracket and
the compartment so that you can disconnect the card from its cable and remove it from the
computer.
card card connector
card door
To Next Page
Loading...
