Adding and Replacing Parts 129
7
Lift up the video card to remove it.
The video-card heat sink is part of the video card assembly.
Processor Thermal-Cooling Assembly
CAUTION: Before you begin this procedure, read the safety instructions at the front of this document
(see page 11).
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching a connector on the back panel of the computer.
Removing the Processor Thermal-Cooling Assembly
1
Follow the procedures in "Before You Begin" (see page 103).
2
Remove the center hinge cover (see page 121).
3
Remove the keyboard (see page 114).
4
Remove the display (see page 124).
5
Remove the keyboard bracket (see page 118).
6
Remove the video card (see page 128).
7
Loosen in consecutive order the four captive screws, labeled "1" through "4," that secure the
processor thermal-cooling assembly to the system board.
video card
M2.5 x 6-mm screws (4)
system board
connector
To Next Page
Loading...
