Adding and Replacing Parts 117
Modem
CAUTION: Before you begin this procedure, read the safety instructions at the front of this document
(see page 11).
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching a connector on the back panel of the computer.
Removing the Modem
1
Follow the procedures in "Before You Begin" (see page 103).
2
Remove the center hinge cover (see page 121).
3
Remove the keyboard (see page 114).
4
Remove the M2 x 3-mm screw.
5
Pull up on the pull-tab to disconnect the modem from the modem connector on the system
board.
NOTICE: Do not disconnect the modem cable from the system board.
6
Disconnect the modem cable from the modem.
M2 x 3-mm screw
pull-tab
modem
modem cable
To Next Page
Loading...
