Dell Inspiron XPS - Video Card

128 Adding and Replacing Parts
www.dell.com | support.dell.com
5 Remove the two M2 x 4-mm screws and remove the display latch.
Video Card
CAUTION: Before you begin this procedure, read the safety instructions at the front of this document
(see page 11).
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching a connector on the back panel of the computer.
1
Follow the procedures in "Before You Begin" (see page 103).
2 Remove the center hinge cover (see page 121).
3 Remove the keyboard (see page 114).
4 Remove the display (see page 124).
5 Remove the keyboard bracket (see page 118).
6 Remove the four M2.5 x 6-mm screws from the video card.
display latch
M2 x 4-mm screws (2)