c) battery
3. Disconnect the DC-in cable from its connector on the system board [1].
4. Remove the two M2L4 screws securing the DC-in port to the palmrest and the system board [2].
5. Flip over the metal bracket on the USB Type-C port of the system board [3].
6. Lift to remove the DC-in port from the computer [4].
Installing the DC-in cable
1. Install the DC-in port in the computer aligning it with the notch in the chassis [1].
2. Ensure that the metal bracket sits flush on the USB Type-C port, aligning with screw holes on the system board [2].
3. Tighten the two M2xL4 screws securing the DC-in to the motherboard and palmrest [3].
4. Connect the DC-in cable to the system board [4].
Disassembly and reassembly
63
To Next Page
Loading...
