3. Perform the following steps to remove the audio-connector board from the computer:
a) Disconnect the audio-connector board cable from the system board.
b) Remove the screw that secures the audio-connector board to the computer.
c) Lift and remove the audio-connector board from the computer.
Installing the Audio-Connector Board
1. Place the audio-connector board in its slot on the computer.
2. Tighten the screw to secure the audio-connector board to the computer.
3. Connect the audio-connector board cable to the system board.
4. Install the:
a) base cover
b) battery
5. Follow the procedures in After Working Inside Your Computer.
Removing the Hard Drive
1. Follow the procedures in Before Working On Your Computer.
2. Remove the:
a) battery
b) base cover
20
To Next Page
Loading...
