5. Slide the palmrest assembly away to release the display assembly.
Installing the Display Assembly
1. Align the palmrest assembly on the display assembly.
2. Tighten the screws to secure the display hinges to the palmrest assembly.
3. Connect the following cables:
a) touch panel
b) network connector
c) display
4. Align the bracket over the display cable and tighten the screw to secure the bracket to the computer.
5. Connect the antenna cables to the WLAN card and route them along their channels on the
computer.
6. Install the:
a) battery
b) base cover
7. Follow the procedures in After Working Inside Your Computer.
30
To Next Page
Loading...
